E40燈頭通規 7006-27-7
Go Gauge For E40 Caps on Finished Lamps
量規螺紋邊緣尖銳部分以0.2mm~0.3mm的半徑倒圓。
The sharp part of the edge of the thread shall be broken with a radius of 0.2mm to 0.3 mm.
目的:
Purpose:
檢驗成品燈上E40燈頭螺紋尺寸和尺寸T1min。
To check the maximum dimensions of the screw thread and dimension T1 minimum of E40 caps on finished lamps.
檢驗:
Testing:
當成品燈上的燈頭完全旋入量規內時,燈頭中心觸點應與X面共面或凸出X面。
When the cap on a finished lamp has been screwd into the gauge as far as it will go, the centre contact shall be co-planar with, or project beyond , surface X.
___________________________________________________
E40燈頭止規7006-28D-1
Not Go Gauge for E40 Caps on Finished Lamps 7006-28D-1
目的:
Purpose:
檢驗成品燈上E40燈頭螺紋外徑(尺寸d)。
To check the minimum outside (major) diameter of the screw thread, dimension d, of E40 caps on finished lamps.
檢驗:
Testing:
當量規套在成品燈(燈頭向上)的燈頭螺紋上時,燈頭中心觸點不應凸出X面。檢驗僅利用量規本身的重量進行。
When the gauge is placed over the thread of the cap on a finished lamps, held cap uppermost, the centre contact shall not projeject beyond surface X. Only the weight of the gauge itself shall be used in the test.