目的:
檢驗成品燈具上BA9、B15、BA15和B22燈頭的尺寸Amax、Nmin、D1min和D1max,以及銷釘?shù)膹较蛭恢谩?/span>
檢驗:
將燈頭插入量規,直至其銷釘通過狹槽Q。然后,將燈頭轉動一微小的角度,并將其按壓,從而使其銷釘與S面緊密接觸。在此位置上形成接觸的面不應低于X面,也不應凸出Z面。
注:如果規定要求檢驗GB/T1406.5-7004-11所示尺寸Dmax,可采用類似的量規檢驗未組裝的B15燈頭。
Purpose:
To check dimension A max. , N min. , Di min. , Di max. , and the diametrical position of the pins of caps BA9, BA15 and B22 on finished lamps.
Testing:
The cap shall enter the gauge until the pins have passed through the slots Q. The cap is then turned through a small angle and is pressed so that the pins are in close contact with surface S. In this position, the contact-making surface shall not be below surface X nor shall it project beyond surface Z.
Note: A similar gauge may be used for checking unmounted caps B15 provided that provision is made for checking dimension D max. as shown on sheet 7004-11.